News-Zhejiang Boyar Pump Technology Co.,Ltd

Daily maintenance of sewage pumps

DATE：2023/8/17 CLICK：738

Daily maintenance of sewage pump:

1.After the self priming sewage pump stops, the remaining water inside the pump and pipeline should be discharged, and the external mud should be cleaned to prevent the frozen water from freezing and causing the pump body and water pipe to burst;
2. Cast iron parts such as the bottom valve and elbow of the sewage pump should be cleaned with a steel wire brush first, then coated with anti rust paint before painting. After drying, they should be stored in a ventilated and dry place in the machine room or storage room;
3. For belt drives, after removing the belt, clean it with warm water and hang it in a dry and dry place without direct sunlight. Do not store it in places with oil stains, corrosion, and smoke. The belt should not be contaminated with oil, diesel or gasoline under any circumstances, nor should it be coated with viscous substances such as rosin;
4. Check the ball bearing. If the inner and outer sleeves are worn, the balls are worn, or there are spots on the surface, they should be replaced. Do not use gasoline or kerosene to clean the bearings, apply butter, and reinstall.
5. Check if there are cracks or holes in the impeller of the sewage pump, and if the fixing nut of the impeller is loose. If there is any damage, please repair or replace it. If the impeller is excessively worn or damaged, it should be replaced with a new impeller. Local damage can be repaired by welding, or the impeller can be repaired with epoxy mortar.The repaired impeller should undergo a static balance test. Check the clearance at the impeller wear reducing ring and repair or replace it if it exceeds the specified value;
6. Pump shafts that are severely bent or worn should be repaired or replaced, otherwise it may cause rotor imbalance and related parts wear;
7. Soak the removed screws in diesel, brush with a wire brush, apply engine oil or butter, reinstall or wrap with plastic cloth, and place them in place to prevent corrosion or loss.